50Pcs Flat Ceramic Floor Wall Construction

Material: High Quality PP + Manganese steel

Color: Black+Orange

Applicable Brick Difference: ＞1.5mm

Applicable Tile Thickness: 5-16mm

*1. Wear-resistant, recyclable, reusable.

*2. Easy to use in DIY operation.

*3. Balance tiles in the same horizontal position.

*4. Improve tile installation speed.

*5. Reduce installer fatigue / pressure.

*6. There is virtually no crackless, flat surface.

*7. This reduces the need for sharpening and polishing.

*8. Avoid shingles from movement during solidification.

1. Due to the different of the monitor and the light effect, the actual color of the item may be slightly different from the color shown in the pictures. Thank you!

2. Please allow slight measurement deviation due to manual measurement.

Usage Tips

Lay the first tile, leaving more than 2mm. Close to tile.

Insert T-pins next to the gap between the tiles. Then rotate 90 degrees and the T-needle is attached to the bottom of the two tiles. Adjust the cover by hand / wrench until the two tiles are on the same level.

After leveling for about 5-6 hours, before the cement / adhesive is completely dry, rotate the lid in reverse and take off the 180 degree T needle.

Avoid not removing the T-leveling tile system

1. Ceramic tile joints are 2mm or more (cross joints are recommended)

2. When leveling, adhesive cement or tile cement around T-type leveler should be cleaned.

3. Remove the T-type straightener about 5-6 hours after leveling before the tile or cement binder is completely dried.

50 * Tile Leveling System Floor Kit 

2 * Wrenchs